CBM CBM1000 Instructions d'exploitation télécharger pdf (Page 53)

— 35 —

7.3.2 Error Detection

Detection of parity errors, framing errors, and overrun errors is provided with this

printer. When an error is detected, the data containing the error is stored in the

buffer as a “?”.

(1) Framing error

If a space state is detected at the timing of stop bit detection, this indicates that

an error has occurred. The data containing the error is stored in the buffer as a

“?”.

(2) Parity error

With parity check specified, when data is parity-checked and an error is detected,

the data containing the error is stored in the buffer as a “?”.

(3) Overrun error

If an overrun error is detected, the data containing the error is stored in the buffer

as a “?”.

7.3.3 Data Reception Control

With DTR/DSR control selected, when DTR signal becomes “Low”, the printer can

receive data from the host computer, but when it is “High”, the printer cannot

receive data. With DTR/DSR control not selected, after sending out X-ON, the

printer receives data from the host computer, but cannot receive data from the

host computer after X-OFF is sent out.

7.3.4 Buffering

When data is transferred to the input buffer, DTR and TD signals are used as

control signals.

• Refer to 7.3.1 (2) for DTR signal.

• Refer to 7.3.1 (3) for TD signal.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 229 230

Pas de commentaire

CBM CBM1000 Instructions d'exploitation Page 53