CBM CBM1000 Instructions d'exploitation télécharger pdf (Page 39)

— 21 —

Buzzer-on Timing

If either of the following printer errors occurred, the buzzer sounds and the

ERROR LED comes on:

1. Paper-End (PE) or Cover Open

Four short "pip" tones sound in 2 cycles at a 0.5-sec. interval.

2. Auto Cutter Error

A continuous "pip" tone and "peep" tone sounds for 1 sec.

Waiting for label cutter action:

Wait until the label discharged by the GS+FF (Cut Label &

Discharge) command is cut by the manual cutter and the

FEED switch is pressed.

If "No Cutter" or "No Peeling Mechanism" is chosen, the

printer becomes Busy.

Label detection error:

Label gaps or black marks could not be detected, or the label

sheets used do not fall in the specified length limits.

If a label detection error occurs even though the label sheets

used fall in the specified length limits, it is most likely that the

sensor or its peripheral electronics is defective. The printer

becomes Busy.

Waiting for label peeling action:

Wait until the label discharged by the GS+FF (Cut Label &

Discharge) command is peeled off the base sheet. If the

"Peeling Mechanism" is chosen, the printer becomes Busy.

FEED switch

• Pressing this switch briefly causes one line of paper feeding. Holding down the

switch causes continuous paper feeding.

• While a macro is waiting to be executed, pressing the switch causes the macro

to be executed.

FEED switch and POWER switch

If you press the POWER switch while holding down the FEED switch, self printing

is performed.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 229 230

Pas de commentaire

CBM CBM1000 Instructions d'exploitation Page 39