CBM CBM1000 Instructions d'exploitation télécharger pdf (Page 129)

— 111 —

(2) If a sufficient area cannot be provided as a result of step

(1), the print area is extended toward the left (So, the left

margin is decreased).

(3) If a sufficient area cannot be provided as a result of step

(2), the right spacing is trimmed.

• When mapping a bit image (Or downloaded bit image), if the

print area is narrower than the minimum width of the bit image

(Two dots for single density, or one dot for double density),

only the line for that image is handled as follows:

(1) The print area is extended toward the left (So, the left

margin is decreased) until it is equal to the minimum width

of the image, but not wider than the printable area.

[Default] nL=64, nH=2 (When 58mm wide paper is used: nL=176, nH=1)

Since the default value varies depending on the number of

columns, refer to “Defing the print area in PAGE MODE; ESC

W”on page 83, for more information.

[See Also] GS L, GS P

(1)

Extended

toward

the right

Printable Area

Left Margin

(2) The left margin

is trimmed

Print Area Width

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 229 230

Pas de commentaire

CBM CBM1000 Instructions d'exploitation Page 129